Honda Insight Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
128 Posts
Discussion Starter #1
So I had to remove my clutch pedal to replace the pad on the sensor. The spring popped out and now no matter which way I put it in it doesn't work right or pops out. Are there any instructions or videos? I can't seem to find anything after searching
87866
 

·
Linsight Designer
Joined
·
1,938 Posts
I just did this a couple months back... it took me a few tries to figure it out, too. Take a look at another G1 and see how the spring (oddly) loops through the linkage.
 
1 - 4 of 4 Posts
Top