[KLR3CYL]

The lower rear bar has been discontinued. Many of the crossbars are damaged when they come in the shop for repairs.

The original part was made from .060
Aluminum.

We make a replacement part that has the correct hole spacing with the proper metric thread inserts. The bar that we make is .125, 6061 aluminum.

Scott

 

[Willie Williford]

What is the cost of that jewel?

 

[Shane M]

I'm almost certain I have one in my basement, if all else fails.

 

[hurricos]

I suspect that bar is the $13 "optional mounting hardware" part listed on killer3cylinder.com (though prices there are a little out of date -- IIRC the panel is $100 plus shipping at this point due to the jump in price of aluminum stock)

I will also need one. I didn't think about it when I ordered my belly panel -- it would be nice if the listing above showed the photo of the replacement for #10 as well @KLR3CYL :^)

 

[Bull Dog]

No, that bar is not part of the optional mounting hardware.