Honda Insight Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1
Hi guys, I need the center to center connecting rod legnth for the Insight engine.

I have picked up both Helms FSM's for the Insight, and it just gives oil clearence specs and wrist pin bore specs.

I really need to have the rod legnth spec to get the piston acceleration graphs finished to begin the cam design.

Thanks in advance!
Best Wishes,
-Luke

PS, were are looking for a number right around 4.8-5.2" (for a typical 1.5:1 honda economy engine R/S ratio)
 
1 - 1 of 1 Posts
Top