Honda Insight Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
466 Posts
Discussion Starter #1
I have hit two dealerships and online fiche and still am not able to find out the proper part # I need. I recently replaced the front bumper on my MY2000. On the bottom of the bumper itself there are 6 slots (3 on each side) on the farthest front outside edge of the bumper that require a little 5mm nut, but this nut is course thread not fine. The nuts go on to hold the black rubber "strake" piece (# 71120-S3Y-000). The screw that goes into them is a either 5x10mm or a 5x15mm course thread screw. Anyone know what the proper part # for these are??? help! It is not 90331-S3Y-003 as these are too small and the cut-out on the bumper itself is fairly large.

Thanks,

Steve
 
1 - 1 of 1 Posts
Top