[Joe’sRedRocket]

Hi.
Does anyone know what this blue wire is for? It’s located between the brake and clutch fluid reservoirs. It’s on a 2000 gen1 with manual trans.

Thanks,
Joe

 

[Willie Williford]

Doesn't look like a stock item.
Where does the blue wire go to?

 

[Joe’sRedRocket]

Doesn't look like a stock item.
Where does the blue wire go to?

From what I can tell, it goes into a section of flexible conduit along with the 2 wires from the brake fluid reservoir. Then I think it goes behind the 12v battery and joins more wires and goes through the firewall.

Here’s a pic of the rubber boot removed.

 

[Tekuno Ichigo]

Brake Master Cylinder Fluid Level Sensor?

Edit: Nevermind, it's the tachometer test plug.

 

[Joe’sRedRocket]

Brake Master Cylinder Fluid Level Sensor?

Yeah I’m curious because there is a connector on the end, but only one wire. The other side where a wire would go through is plugged.

 

[Tekuno Ichigo]

Yeah I’m curious because there is a connector on the end, but only one wire. The other side where a wire would go through is plugged. View attachment 97062

It was my mistake. I edited my previous post and corrected it. It's the tach signal test port.

 

[Joe’sRedRocket]

It was my mistake. I edited my previous post and corrected it. It's the tach signal test port.

Thank you very much!
Joe