Does anyone have a picture of how the front splash shields are supposed to fit together. The reason I'm asking is because I'm trying to refit mine to the car after changing the oil etc... I just purchased the car a couple of weeks ago and noticed when I took them off the two plastic pieces bow downward when I try to refit them. All of the holes line up properly except the ones where the two plastic pieces attatch to the metal piece. The holes are off by about an inch. I have to push toward the rear of the car in order to get the screws in. This makes them bow downward. Thanks
Splash shields
1 - 6 of 6 Posts
What you need is one of Scott's belly pans. Stronger, and don't warp because of an oil leak.
Look here:
Look here:
Killer3cylinder
Killer3cylinder.com is dedicated the the Gen 1 Honda Insight owner enthusiast. We are located in Southern California. We drive, repair and sell parts for these vehicles. Below are some of the...
www.killer3cylinder.com
Definitely looking into the metal pans. I think I figured out what's going on with these though. The little brackets that hold the front of the aluminum piece were pretty bent up. I'm working on straightening them now. Hoping it will fit together a little bit better until I can get one of the metal ones.
Where do i get these pans?What you need is one of Scott's belly pans. Stronger, and don't warp because of an oil leak.
Look here:
Killer3cylinder
Killer3cylinder.com is dedicated the the Gen 1 Honda Insight owner enthusiast. We are located in Southern California. We drive, repair and sell parts for these vehicles. Below are some of the...www.killer3cylinder.com
1 - 6 of 6 Posts
